Wheelock MT4-12-LS Guía para resolver problemas descargar pdf (Pagina 56)

–56–

Section 14. REMOTE PROGRAMMING AND

CONTROL (DOWNLOADING)

General Information

The Ademco 5110XM can be remotely programmed from an IBM compatible

Personal Computer (PC), a HAYES Modem, and Ademco's V-LINK® Software

(as specified below).

Programming the control from a remote location is protected against

compromise by someone attempting to defeat the system, using multi-levels

of security protection:

1. Security Code Handshake: An 8-digit download ID code must be

matched between the control and the downloader .

2. Site Initiated Remote Programming: The installer initiates the

callback from the subscriber premises (by entering Master code + # + 1).

All parameters can then be downloaded via the phone lines using a per-

sonal computer.

3. Station Initiated Remote Programming: The operator calls the site

from your office to initiate the download call. The control hangs up and

then calls back the PC via the preprogrammed telephone number. The

unit can then be uploaded, downloaded, or controlled from your office.

4. Data Encryption: Data passed between the PC and the control is en-

crypted for security so that it is very difficult for a foreign device tapped

into the phone line to take over communication and substitute system

compromising information.

Remote programming may only be used when a service technician is at the site

during downloading.

Equipment Required

At the premises:

- Ademco 5110XM and keypad.

At the installer's office/home:

- An IBM PC compatible computer.

- Either a HAYES brand SMARTMODEM 1200 [Level 1.2 or higher external

or Level 1.1 or higher (with 4 position DIP switch) internal style],or a

HAYES brand Optima 24 Plus FAX96 Modem (set Aux Modem command to:

X&D2&C1&Q0).

- V-LINK® Downloading Software Diskette (at revision level 3.1 or higher).

- Appropriate interconnecting cables.

Initial Download

Site Initiated:

1. Enter program mode by entering Master code (5110) + 80.

2. Program the download phone number in field *94.

3. Initialize the download ID and subscriber account number by entering *96.

4. Exit program mode by entering *98 (prevents re-entry using Master code)

or *99 (allows re-entry using Master code).

5. Wait approx. 1 minute for system to stabilize. Then initiate the downloading

session by entering Master code + # + 1 (this causes the control to make the

phone call).

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 75 76

Comentarios a estos manuales

Sin comentarios

Wheelock MT4-12-LS Guía para resolver problemas Pagina 56

Comentarios a estos manuales

Relacionado con productos y manuales para Detectores de humo Wheelock MT4-12-LS