Wheelock MT4-12-LS Guía para resolver problemas descargar pdf (Pagina 21)

– 21 –

02 Report Code

1st 03 2nd 12 3C

The report code consists of 2 hexadecimal digits,

each in turn consisting of 2 numerical digits. For

example, for a report code of "3C", enter [0][3] for

"3" and [1][2] for "C". Refer to Section 11.

SYSTEM COMMUNICATION for complete

information on report codes, if necessary.

Enter the desired report code and then press [*] to

continue.

Typical summary display

Zn ZT RC

02 09 3C

A summary display will appear, showing the data

for the zone that was just programmed.

If it is programmed satisfactorily, press [*] to

continue.

Program Alpha?

0 = No 1 = Yes 0

The next request is to enter Alpha descriptors for

the zones. The entry may be done now (enter 1) or

may be done at a later time using *82 interactive

mode (enter 0). We recommend that the entry of

Alpha descriptors be done using *82 mode.

Enter Zn Num.

(00 = Quit) 02

If “0” (no) was entered above, the system will

return to the "Enter Zone Number" prompt.

Proceed with the programming for the next zone,

as indicated previously.

When you have programmed all the detection zones

satisfactorily, exit

*56

interactive mode at the

Enter Zn Num. prompt by pressing: [0] [0]

Then exit the programming mode by keying

99.

Proceed to the check-out procedure that follows.

Check-Out Procedure For Detection Zones

After installation of all devices is completed, the system should be checked, as

follows.

1. Make certain that all devices and sensors connected to the zones are not in

a faulted state.

2. Power up the control if you have not already done so..

3. After a 50 second delay, with all zones intact, the AC Power LED should be

ON and the warning buzzer should be OFF. If an optional Alpha keypad is

connected you should see the following display:

**** SYSTEM ****

**** NORMAL ****

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 75 76

Comentarios a estos manuales

Sin comentarios

Wheelock MT4-12-LS Guía para resolver problemas Pagina 21

Comentarios a estos manuales

Relacionado con productos y manuales para Detectores de humo Wheelock MT4-12-LS