
P83259 H
Sheet 5 of 26
4. APPLICATION DIAGRAMS
:
The following application diagrams show the seven basic system configurations of the MZC-144 and its companion MZEM-3.
All of these configurations are possible with the appropriate configured switch selections. Figures 2, 3, 4, and 5 are typical
configurations using central amplifiers. Figure 6 is a typical configuration using amplified speakers. Figures 7 and 8 are typical
configurations using zone amplifiers.
Figure 2:
One Central Amplifier which has music mute, page input and music input.
(One Way Paging and/or Optional Talk-Back)
In this application, the one central amplifier for both paging and background music has music muting and separate inputs
(volume controls) for paging and music. The system uses speakers with built-in line matching transformers for both One Way
paging, and paging with optional Talk-Back.
MUSIC
SOURCE
POWER
SUPPLY
24VDC
25V/70V/100V
A
GND (+)
ZONE 1
FROM TELEPHONE *
CENTRAL
AMPLIFIER
WITH TRANSFORMER
+
-
TYPICAL SPEAKER
BACKGROUND
TYPICAL SPEAKER
WITH TRANSFORMER
AMP. 1
MZC-144
AMP. 1
SYSTEM
W/MUSIC MUTE
ZONE 12
(-) 24VDC
OUT
IN
(PAGING & BACKGROUND MUSIC)
(SEE NOTE)
MUSIC
ZONE 1
ZONE 2
ZONE 3
MUSIC
ZONE 4
ZONE 5
ZONE 6
MUSIC
ZONE 7
ZONE 8
ZONE 9
ZONE 10
ZONE 11
ZONE 12
GROUP 1
MZEM-3
#1
GROUP 2
MZEM-3
#2
GROUP 3
MZEM-3
#3
GROUP 4
MUSIC
* NOTE: Use Tip CO and Ring CO for stand alone telephone, unused CO line/trunk port, or 600 ohm audio page port connections.
NOTES:
1. If the central amplifier does not provide music mute, then the background music source is connected as shown in Figure 3.
2. In systems with optional Talk-Back paging, install one background music source only as shown. DO NOT connect
background music source directly to zone group music inputs as improper operation may result.
Comentarios a estos manuales